+27 (0)11 022 5323 +27 (0)72 435 0005
R
- -
MagnifierSearch:
Relay click (Go to Parent Category)

Relay click RELAY Click board features two G6D1AASI-5DC power PCB relay modules as well as two screw terminals. It communicates with the target microcontroller via mikroBUS PWM (RL1) and CS (RL2) pins. A green LED diode indicates the presence of power supply. Controls up to 5A, 250V AC/30V DC loads. The board is designed to use a 5V power supply only, however communication lines voltage level can be in the range of 1.8V to 5V as on-board transistors are used to drive the relays by current sinking.
R275  Qty:
Weight: 50g. Stock: 1 available immediately [i]. mikroE Icon
Relay4
Relay4 The Relay4 Board is a small-sized board with 4 Relays (each supports currents up to 16A). It also contains ULN2803 (high-current Darlington arrays) for driving relays and an IDC10 connector for easy connection with a development or prototype board (an IDC10 cable is included).
R460  Qty:
Weight: 60g. Stock: 1 available immediately [i]. mikroE Icon
Relay 2 click (SSR)
Relay 2 click (SSR) Relay 2 click carries two LCA717 single-pole, OptoMOS solid state relays and two screw terminals for connecting the wiring. These relays have a load current of 2A, low maximum on-resistance of just 0.15 Ohms, and a blocking Voltage of 30V. The LCA717 have optically coupled outputs that use the patented OptoMOS technology. Solid state relays enable fast, silent and bounce-free switching. Each relay is coupled with an onboard signal LED. The board is designed to use a 3.3V power supply only.
R400  Qty:
Est. Weight: 25g. Stock: 1 available immediately [i]. mikroE Icon
Signal Relay click
Signal Relay click Signal Relay click can be used for ON/OFF control in various devices. It carries four ultra-small GV5-1 PCB relays from Omron and runs on a 5V power supply. Signal Relay click communicates with the target MCU over the following mikroBUS pins: AN, RST, CS and PWM.
R445  Qty:
Weight: 45g. Stock: Available in 5-10 working days [i]. mikroE Icon